MCD 是如何生产 mcd flurry 汤池

xIAo_L

啊啊啊！请问如何生产mcd flurry 汤池 ？救命！救命！

operaqwes

希望能帮到你！加油

A design is first drawn on paper. Both sides should be made exactly alike by folding a piece of paper down the center and drawing one-half of the spoon on one side of the center line. Fold the paper and rub the design on the back with some hard object, and the drawing will be transferred to the other side of the center line. Transfer the design on to a piece of 18-gage copper, and cut to the line with the shears, or saw it out with the jeweler's saw. MCD Plastic Spoon will undergo for testing by Guppy plastic factory to  find out whether it is easy broken or stiffness or even colour standing duration.
Then place the spoon bowl over the hollow in the block of hard wood that was used in making bowls, and with the ballpein hammer beat the spoon bowl into the hollow as smoothly as possible.
The handle, if it were left flat, would not be stiff enough to serve its purpose, so a ridge is raised down the center of its entire length for the purpose of stiffening it. This is done by laying the handle face downward on a piece of soft wood and using a thin neck hammer to beat up the ridge. This ridge can plainly be seen in Fig. 151; in Fig. 152 it is not defined so sharply, but it may be seen that the narrow shank of the handle is well rounded to give the required stiffness.Guppy plastic Factory have successfully produced  MCD plastic spoon after evaluation and improvement and mould start to be producing to prepare for mass production
After the spoon is beaten into shape on the wood, it is carefully planished, polished, colored, and waxed. When using this first method, great care must be taken to make the spoon stiff. If this is not done, the spoon will bend when used, and there is no greater abomination than an object that is so poorly constructed that it breaks down when put to the use for which it was designed.