本帖最后由 mokakika 于 14-7-2017 09:45 PM 编辑
~kvr13n9s8/4~
~只卖RM120(全新)拆了试下罢了~
~出售原因:11-7-2017 在LAZADA RM140买了 kvr13n9s8/4 打算装在我的旧电脑,发现motherboard太旧support不到(所以亏本卖)~
~(Life Time Warranty)能提供receipt 证明在11-7-2017买的(receipt跟RAM一起寄)
Kingston 4GB DDR3 Desktop RAM (1333MHz - KVR13N9S8/4)
• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 667MHz fCK for 1333Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration: Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• PCB: Height 0.740” (18.75mm) or 1.180” (30.00mm)
|